Finishing & Specialty Products

Show sidebar
Insta-Cure
Close

Insta-Cure

$16.10$40.25 (inc. gst)
Insta-Cure has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a
Insta-Cure+
Close

Insta-Cure+

$16.10$40.25 (inc. gst)
Insta-Cure+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker
Maxi-Cure
Close

Maxi-Cure

$16.10$40.25 (inc. gst)
Maxi-Cure extra thick CA is the best CA for most plastics, including GE’s Lexan. MAXI-CURE™ is the best choice for
Insta-Set CA Accelerator
Close

Insta-Set CA Accelerator

$23.00$46.00 (inc. gst)
Insta-Set CA Accelerator is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers
Close

Zap-a-Gap (Pink)

$23.00$57.50 (inc. gst)
Zap-a-Gap superglue allows 7 to 10 seconds for positioning, 20 seconds cure time. To accelerate use Zip Kicker. Bonds anything
Close

Zap-a-Gap (Green)

$28.75$57.50 (inc. gst)
Zap-a-Gap superglue allows 7 to 10 seconds for positioning, 20 seconds cure time. To accelerate use Zip Kicker. Bonds anything
Close

Z-Ends & Tubing

$13.80 (inc. gst)
Close
Close
Close

Z-Poxy 5 mins

$57.50$80.50 (inc. gst)
5 Minute Z-POXY is a premium two-part epoxy adhesive that dries clear. Vibration resistant and fuel proof, this epoxy is
Close

Z-Poxy 30 mins 8oz

$80.50 (inc. gst)
Close
Close

Z-7 Debonder 1oz

$13.80 (inc. gst)
Close

Brass B Coating

$57.50$460.00 (inc. gst)
The Metal Coatings are ground metal suspended in a non-toxic water based acrylic binder. They may be applied to both
Close

Bronze B Coating

$57.50$598.00 (inc. gst)
The Metal Coatings are ground metal suspended in a non-toxic water based acrylic binder. They may be applied to both
Close

Copper B Coating

$57.50$460.00 (inc. gst)
The Metal Coatings are ground metal suspended in a non-toxic water based acrylic binder. They may be applied to both
Close

Iron B Coating

$40.25$322.00 (inc. gst)
The Metal Coatings are ground metal suspended in a non-toxic water based acrylic binder. They may be applied to both

Prime-It for Metal Coatings

$57.50$345.00 (inc. gst)
When applying traditional or acid patinas to the Metal Coatings over iron, steel, or aluminum, a primer must first be
Close

Antiquing Patina

$21.85$276.00 (inc. gst)
Antiquing Patina is used to create an aged brown to black finish on bronze, brass, and copper. On iron, steel
Close

Darkening Patina

$21.85$299.00 (inc. gst)
Darkening Patina is most commonly used cold on bronze, brass, and copper to produce a beautiful brown finish. This patina
Close

Ferric Nitrate/Chloride

$23.00$287.50 (inc. gst)
Ferric Nitrate/Ferric Chloride Patina produces a transparent red brown finish when applied hot to bronze, brass, and copper. Similar to
Close

Japanese Brown Patina

$21.85$299.00 (inc. gst)
Japanese Brown may be used on bronze, brass, and copper resulting in a golden brown finish, but it is most
Close

Liver of Sulfur

$51.75 (inc. gst)
This is a mixture of potassium sulfides which has traditionally been used to darken or ‘antique’ silver and bronzes. This
Close

Tan Patina

$23.00$345.00 (inc. gst)
Tan Patina is used to achieve an opaque tan finish on all metals. It may be applied hot or cold
Close

Black Magic Patina

$23.00$460.00 (inc. gst)
Black Magic Patina creates a beautiful, rich black patina on iron and steel. It takes only 3-5 minutes to develop
Close

Midnight Black Patina

$51.75$460.00 (inc. gst)
Traditional Midnight Black Patina reacts on aluminum, bronze, brass, copper, iron, steel (not stainless), and zinc/galvanized. This patina works quickly
Close

Slate Patina

$51.75$460.00 (inc. gst)
Slate Black Patina is a versatile black finish for use on most metals. On iron and steel, it is used
Close

Stainless Black Patina

$51.75$517.50 (inc. gst)
Stainless Black Patina is made specifically for stainless steel. It is not recommended for other metals, but on zinc and
Close

Powder Blue Patina

$40.25$287.50 (inc. gst)
Powder Blue is a cold patina for bronze, brass, copper, and the Metal Coatings. This patina results in a stable
Close

Light Green Patina

$21.85$299.00 (inc. gst)
Light Green Patina is a cold patina for bronze, brass, and copper. Apply to a clean, cold (65°-70°F) metal. It
Close

Tiffany Green Patina

$23.00$299.00 (inc. gst)
Tiffany Green is a cold patina for bronze, brass, and copper. It may be used both indoors and outdoors. If
Close

A14 Black For Aluminium

$57.50$575.00 (inc. gst)
All Birchwood patinas are considered traditional patinas that will age or darken metal. These patinas are sold concentrated and should
Close

M20 (Dip) Black Patina

$34.50$575.00 (inc. gst)
All Birchwood patinas are considered traditional patinas that will age or darken metal. These patinas are sold concentrated and should
Close

M24 (Spray) Black Patina

$51.75$782.00 (inc. gst)
All Birchwood patinas are considered traditional patinas that will age or darken metal. These patinas are sold concentrated and should
Close

M38 Antique Brown Patina

$57.50$483.00 (inc. gst)
All Birchwood patinas are considered traditional patinas that will age or darken metal. These patinas are sold concentrated and should
Close

PC9 (Spray) Black Patina

$63.25$575.00 (inc. gst)
All Birchwood patinas are considered traditional patinas that will age or darken metal. These patinas are sold concentrated and should
Close

Rainbow Patina

$149.50 (inc. gst)
Traditional Rainbow Patina is a very interesting finish. Depending on the application method and the metal used, many different finishes
Close

Patina Stain Spray

$103.50 (inc. gst)
Patina Stains are blended to match chemical or Traditional Patinas without the fuss. They are pre-blended Solvent Dyes and Clear
Green Blue Dye Oxide 32oz
Close

Green Blue Dye Oxide 32oz

$230.00 (inc. gst)
Dye-Oxide Patinas are a cross between the Solvent Based Dyes and a patina. All of the colors are transparent and
Close

Contemporary Patination by Ron Young

$253.00 (inc. gst)
Contemporary Patination, 2nd edition, is a thorough recipe book of hot and cold patinas for bronze, brass and copper. Instruction

ColorLoc Spray

$92.00 (inc. gst)
ColorLoc is a crystal clear, air drying lacquer that locks in the color of torch heated metals. It has excellent
Close

Clear Guard Spray

$74.75 (inc. gst)
Clear Guard Spray is a protective lacquer for all metals which guards against sun, mild acids, salts, heat and water.
Close

Clear Guard EF Spray

$80.50 (inc. gst)
Clear Guard Spray Environmentally Friendly is a protective lacquer for all metals which guards against sun, mild acids, salts, heat
Close

Clear Guard Satin

$195.50$460.00 (inc. gst)
Clear Guard Spray Satin is a protective lacquer for all metals which guards against sun, mild acids, salts, heat and
Close

Ever-Clear Matte

$189.75$207.00 (inc. gst)
Sculpt Nouveau Ever-Clear acrylic urethane is a two part clear, durable, low VOC, air drying coating. It is formulated for
Close

Ever-Clear Satin

$207.00$598.00 (inc. gst)
Sculpt Nouveau Ever-Clear acrylic urethane is a two part clear, durable, low VOC, air drying coating. It is formulated for
Close

Black Wax For All Metals

$34.50$862.50 (inc. gst)
The finest quality waxes have been blended into a nonabrasive formula specifically to protect patinas and metal finishes. These waxes
Close

Clear Wax For All Metals

$34.50$632.50 (inc. gst)
The finest quality waxes have been blended into a nonabrasive formula specifically to protect patinas and metal finishes. These waxes
Close

Metal Cleaner

$34.50$138.00 (inc. gst)
Sculpt Nouveau Metal Cleaner and Degreaser has been specially developed for the rapid and complete removal of rust, dirt, oil,
Close

Stone Coat Polishing Kit 2 x 16oz

$103.50 (inc. gst)
This kit contains 16 ounces (453 grams) of Polishing Compound and 16 ounces (453grams) of Liquid Smooth Cleaner. The Compound
Close

Microgloss 1oz

$20.70 (inc. gst)
Micro-Gloss (blue label) is a general all-purpose water-based liquid abrasive which uses a one-micron Aluminium oxide abrasive crystal to achieve
Close

Microgloss No.5 1oz

$19.55 (inc. gst)
POL-Micro5-1oz
Close

Craft Polishing Kit

$92.00 (inc. gst)
A unique and handy polishing kit for resin casters. This kit contains everything you need to take those casts, especially
Close

Padset 2x2in 9pack

$92.00 (inc. gst)
Close

Micromesh 3 x 4in 9pack

$161.00 (inc. gst)
POL-Sheetset
Close

Wet & Dry Sponge

$5.75$23.00 (inc. gst)
Wet and Dry sponge is perfect for sanding metals, automotive finishes and for sanding resin down to a smooth finish.
Close

Wet & Dry Sandpaper

$3.45 (inc. gst)
Wet and Dry sandpaper is perfect for sanding metals, automotive finishes and for sanding resin down to a smooth finish.
Close

Bronze Wool

$34.50 (inc. gst)
A high quality bronze wool that is used when buffing or polishing back a bronze surface. This eliminates the problems
Close

Steel Wool 500gm

$51.75$69.00 (inc. gst)
Steel Wool may be used to abrade the surface of cold cast parts to expose the metal particles within the
Close

Breakable Glass Silicone Rubber

$161.00$4,025.00 (inc. gst)
A low strength addition curing, two component silicone rubber that cures at room temperature and features excellent flow due to
Close

Smash-It

$69.00$230.00 (inc. gst)
SMASH-IT is a breakaway blend made from high quality resins and polymers to give a unique glass effect. This product
Close

Jelly Wax

$28.75$138.00 (inc. gst)
Jelly wax, also commonly known as gel wax, is a clear, dimensionally stable, jelly-like material made from specially processed mineral
Close

Isopropyl Alcohol

$19.55$115.00 (inc. gst)
Isopropyl Alcohol is probably the most essential product to have on hand at any time, especially in the make-up kit.
Close

Isopropyl Myristate

$23.00$207.00 (inc. gst)
Isopropyl Myristate is an oil based remover that is incredibly gentle on the skin. Good for removing regular make-up, grease
Close

ProTac Acrylic Adhesive

$21.85$793.50 (inc. gst)
Monster Makers Brand exclusive acrylic adhesive used to adhere many types of prosthetic appliances. Pro-Tac will work for latex, foam