Challenge 95 is primarily a release for flexible and rigid polyurethane elastomers and foams. It can be used for other polyurethane systems as well, however, it is advisable to test prior to its use. Challenge 95 is a universal release for plaster, metal, urethane, and epoxy molds.
Stoner E236 Urethane Mold Release is specially formulated as a release agent and anti-stick lubricant for molded urethanes. A light coating produces best results.
Stoner E302 Rocket Release is an extremely versatile release agent which is generally acceptable for applications where a food grade release is required. In many applications, Rocket Release is considered to be the most paintable release agent available when molding plastics and similar materials.
Stoner A324 Rapid Release is specially formulated to release molded silicone rubber, thermoset plastics, rubber, and similar materials. It provides a long lasting, thin-layer of anti-stick coating for fast, easy part removal from metal, plastic, rubber, and even silicone rubber molds.
Water based release. An emulsion of silicone oils and resins. When used with a spray applicator, it is an economical alternative to aerosol release agents. The use of a soft brush to distribute the release agent evenly may improve results. Primary use is for polyurethane and latex moulds when casting cement based products.
Classed as a general purpose release agent, however it far surpasses most release systems on the market. Designed for use at moderate temperatures where a silicone release is not desired. It provides a matte finish when applied and can also be polished when applied to rigid surfaces. J-WAX is perfect to PU-PU moulding.
This is a versatile lubricant for use as a mould separator. It can be used full strength or diluted with water. Most popular for plaster and gypsum moulds.
A special formula release agent for the fiberglass industry. This product is designed to prevent lamination of the product to the mould. Preventing the mechanical or chemical bonding of the molded material to the surface of the mould. PVA is a film-forming solution, which places a positive barrier between the mould and the product or component.
This material allows the user to laminate fibreglass moulds directly onto wet clay. The vinyl spray is applied to the clay surface as a barrier coat to seal in any moisture from the clay sculpt or walls. Use in conjunction with a suitable release agent such as J-Wax. The Vinyl Spray also imparts some protective properties to the sculpt while the moulds...