Pol-Ease® 2300 Release Agent is a silicone-based release agent in an aerosol can. It should be shaken, sprayed (using the supplied spray straw to make a more uniform mist) then brushed out onto a sealed or non-porous model before applying liquid polyurethane mould rubber. PolEase® 2300 Release Agent is NOT recommended for use when making silicone moulds, as inhibition or sticking may occur.
Once a polyurethane mould is made, Pol-Ease® 2300 Release Agent can also be applied to its surface to release casting materials such as polyurethane liquid plastics, rubbers or epoxies. Pol-Ease® 2300 Release Agent can also be used as a release for stickier foundry waxes, concrete and more.
Pol-Ease® 2300 Release Agent needs to be washed off of cast parts thoroughly before they can be painted, stained, or finished. Pol-Ease® 2300 Release Agent can be cleaned with repeated washings of water and detergent or some citrus degreasers. All paints and stains bond differently to surfaces, especially those previously coated with a release agent. Perform testing to determine if the release agent used will adversely affect this process. If Pol-Ease® 2300 Release Agent makes finishing your cast part difficult, Pol-Ease® 2500 Release Agent may be a good option.
For Mould Making:Apply to non-porous or sealed models when making polyurethane rubber or plastic moulds (do not use with liquid silicone systems).
For Casting:Apply to cured polyurethane molds when casting a variety of materials, including polyurethane liquid plastics, rubber or epoxies.
After spraying, brush out this release agent with a soft brush to help improve results. No drying time necessary.
