This ready to use silicone mould is great for creating a resin candle holder. These moulds are great for Epoxy and UV resin casting. No release agent is required. Keep away from abrasive materials to avoid scratching the silicone. Mould may be washed with warm, soapy water.
Measurement: approx. 5.7cm (Diameter) x 4.4cm (H) / 2.24″ (Diameter) x 1.73″ (H)
Previous product
Back to products
SC94 Single Component Coating
From $172.50
Next product
Hamsa Palm DishSilicone Mould
$23.00 (inc. gst) $11.50 (inc. gst)
Candle Holder Silicone Mould
$26.45 (inc. gst) $13.23 (inc. gst)
Available at:
Auckland
Description
Related products
Plastic Putty Knife 3 inch
Plastic Putty Knives are the perfect tool for successfully mixing urethane or silicone in large volumes. Flat blade helps scrape
Barnes 6L Vacuum System
This vacuum degassing unit is designed to remove air from resin and silicone systems prior to pouring. It is a
Geltex Latex Thickener
Geltex Latex Thickener is used in latex moulding rubbers. Add up to 2% and shear mix until the desired consistency
Measuring Cup 60ml
These 60ml measuring cups can be used to measure small volumes of resin, silicone catalyst, or for decanting small volumes
Plastic Putty Knife 1.5 inch
Plastic Putty Knives are the perfect tool for successfully mixing urethane or silicone in large volumes. Flat blade helps scrape
Woven Bangle Mould
MLD-B1
Glossy Cuff Bangle Mould
MLD-B13
AntiCrak Fibre 13mm 500g
The AntiCrak Fibre 13mm 500g is a premium Alkali-Resistant Fiber used for concrete crack control or gypsum casting. Low percentages
